Artificial Load For Testing Battery
Description
Artificial load is used for testing Exchange battery, UPS, Invertors etc. It is available in different ratings. There is a provision to change current in step. Overload protection is also provided. Unit is portable with wheels. Necessary cables are provided to connect it to battery.
Features
- Easy to use operation. Any layman can use it
- Available in different ratings
- Voltage & load current indication
- Overload protection
- Good ventilation maintained to avoid excessive heat
- Portable to transfer on wheel
- Less power loss in connecting cable
- High power switching
- Wide range of batteries covered
- Accuracy within 5%
Operation
Connect battery under test .Select load current. It should be 10% of AH of battery capacity. Switch on unit. Unit will indicate battery voltage as well as current. Monitor battery voltage continuously. If it falls below specified threshold value disconnect battery from load bank & note down timing.
Specification
| Discharge Current | Selective in step of 10 Amps |
| Protection | Overload protection |
| Load Resistors | High wattage |
| Accuracy | 3% |
| Indication | Voltage & current |
| Cooling Provision | Fan provided in higher ratings |
| Portability | Wheels provided |
| Efficiency | 95% |
| Weight | Varies with respect to models |
| Dimensions | Varies with respect to models |
| Accessories | Operation manual, Testing leads |
| Environmental Spec. | Operation: 0 C to 50 C, Storage: -10 C to 60 C |